1X660MW S.E.T.P.P.E.M.T.T.N-600057

1X660MW S.E.T.P.P.E.M.T.T.N-600057(1X660MW SUP ENNORE THERMAL POWER PROJECT ENNORE, MADHAVARAM TALUK, TAMIL NADU-600057)

CLINT-LANC0

Concrete, ready mix, M30, Pile concreting for pile Dia-750 mm dia.

Supplying and transpiration in position approved design mix concrete of grade M-30 at all depts. (With 20mm nominal sixe graded stone aggregate), for piling with all Labour , material, equipment, handling, batching, transportation, testing, mix design, mixing, workability, conveying, placing by termie method within 6 hours of completion of pile boring, maintaining top of the concrete in pile above the cut of level, including ensuring levels alignment during installation preparation of pile head, preparation of scheme for concretion, all complete as per specification, drawing and instruction of the engineer in charge. Minimum cement content should the 400Kg/cum of the concrete pile head breaking is not included in this item. (Rate should be exclusive of cement and design mix admixture since both these will be free issue by LITL).

1.       Conducting initial load test on cast in situ bored piles (excluding cost of installation of piles which.is to be paid separately under relevant terms),including provision and erection of all kentledge,

  • (including boring and installation of anchor/anchor piles; if required)supporting blocks, loading, frame, necessary, load arrangements for carry out test, excavation, dewatering, backfilling with proper compaction of pile test pit, preparing the scheme for pile testing and pile head for conducting the test and submission of test results etc. with all labour ,material ,equipment, handling, transportation, testing etc. completed as per the approved scheme, drawings, specification, and instruments of the engineer in charge for piles.

 

  1. Initial vertical (cyclic ) load test upto 3 time vertical load carrying capacity on the following piles.

Conducting initial vertical (cyclic) load test on pile for pile dia.-600mm 180 T capacity

Conducting initial vertical (cyclic) load test on pile for pile dia.-750mm 250 T capacity

  1. Initial lateral load test upto 3 time vertical load carrying capacity on the following piles.
  2. Conducting initial lateral load test on pile for pile dia.-600mm dia.-12 T capacity
  3. Conducting initial lateral load test on pile for pile dia.-750mm dia.-16 T capacity

VALUE-7.5CRORE